You may also be interested this post if you have time.. it will be helpful
Maker Steve’s 3D Printing Rules to successful 3D Prints
Be sure to enter win the Whiskey Stash Giveaway for September 2018. You could win a free 3D Printed Whiskey Stash 105mm Howitzer Shell – Replica!
Using your highly modified Creality CR-10S 3D Printer https://amzn.to/2LT8YQB
Print the Base upside down with a Brim to make it stick
Timelapse of the Fuze Printing
Timelapse of the Top Printing
Sand of the high points and trim with razor as needed.
Allow paint to dry at each step.
Paint the Fuze with some Rust-oleum Gloss Black https://amzn.to/2Kp6eoo
Paint the Body with some Aervoe Woodland Green https://rover.ebay.com/rover/1/711-53200-19255-0/1?mpre=https%3A%2F%2Fwww.ebay.com%2Fi%2F183334263902%3Fchn%3Dps&campid=5338222017&toolid=20008 Because I buy it by the 6 pack.
Tape the Obturating Band with Painter’s Tape https://amzn.to/2OHipjI
Paint the Obturating Band with Rust-oleum Copper Rose https://amzn.to/2vmnCW0
Attach the Stencil with Painters tape and cover with paper
Paint with Rust-oleum Gloss Sun Yellow https://amzn.to/2Kp6eoo
Enjoy!
And.. Load it up!
BRAG!
