3D Printed 105mm MGS Big Pig!

Turns a 105mm MGS Tank Casing into a very large Piggybank! Coming soon to my store on Etsy

Artillery Shell Pen Holder

See it here: https://www.thingiverse.com/thing:3124568  or buy one on eBay! Finish them in accordance with Makersteve’s instructions located here: https://makersteve.com/2018/03/26/finishing-your-3d-printed-105mm-artillery-shell-piggy-bank/ If you are new to 3D printing or have a CR-10 and want to pep it up, check my about page in my profile.. lots of good info there. I work for tips and you all don’t tip […]

The ArtillerLamp – BIG BORE! 155mm

Be sure to enter win the Whiskey Stash Giveaway for September 2018. You could win a free 3D Printed Whiskey Stash 105mm Howitzer Shell – Replica! The latest in the ArtillerLamp Family Goes with a 3D Printed 155mm Artillery Shell and a DIY Lamp Kit. Just print https://www.thingiverse.com/thing:2865358 And add a… A Make a Lamp Kit […]

The Whiskey Stash V2 – The King of Bottle!

Thanks to Tculpepp on Thingiverse for a great idea! Get it here! https://www.thingiverse.com/thing:3034854 -or- Contact me I will work a deal to print you one! This is the upgraded and final version of the Whiskey Stash. The print works, the system has been tested and it is ready for combat. Send some friendly fire today. […]

Get your USMC Cannon Bar Taps…

I was asked to modify my Cannon Bar Tap by a Devil Dog from Camp Lejune for use at Fiddler’s Green. I couldn’t let them use any old Bar Taps so I worked something up a little custom for them. Swing by and get a pint, or two. They should be installed shortly. https://www.thingiverse.com/thing:2897408 https://www.thingiverse.com/thing:2897404 […]

Behold! The Cannon Bar Tap Version 2

This bar tap was created upon request! Get it here! https://www.thingiverse.com/thing:2895794 Redlegs! As requested with threaded hole on breech end. Working on a project for the St. Barbara’s Ball. Everyone likes cannons and everyone likes beer.. this is both. It’s a fatty, 9 inches tall by 2 inches wide. print it standing on breech end […]

Finishing your 3D Printed 105MM Artillery Shell Piggy Bank

Step 1:  Paint your shell with some good quality ultra-flat camo paint – This is hard to find!  You want Aervoe, Woodland Green 990. Dries to touch pretty quickly. Step 2: Tape your Stencil on. Step 3: Paint your stencil with some good quality yellow paint!  I use Rustoleum Sun Yellow Step 4: Tape your […]